INJECTION MOLD P3 1 Open Flash
In an open flash mold a slight excess of molding powder is loaded into the mold cavity (FIGURE PP.1a). On closing the top and bottom platens, the excess material is forced out and flash is formed. The flash blocks the plastic remaining in the cavity and causes the mold plunger to exert pressure on it. Gas or air can be trapped by closing the mold too quickly, and finely powdered material can be splashed out of the mold. However, if closing is done carefully, the open flash mold is a simple one, giving very good results.
Since the only pressure on the material remaining in the flash mold when it is closed results from the high viscosity of the melt which did not allow it to escape, only resins having high melt viscosities can be molded by this process. Since most rubbers have high melt viscosities, the flash mold is widely used for producing gaskets and grommets, tub and flash stoppers, shoe heels, door mats, and many other items. Because of lower pressure exerted on the plastic in the flash molds, the molded products are usually less dense than when made using other molds. Moreover, because of the excess material loading needed, the process is somewhat wasteful as far as raw materials are concerned. However, the process has the advantage that the molds are cheap, and very slight labor costs are necessary in weighing out the powder.
|
