INJECTION MOLD P4 1 Ejection of Molding
Ejection of a molded plastic article from a mold can be achieved by using ejector pins, sleeves, or stripper plates. Ejector pins are the most commonly used method because they can be easily fitted and replaced. The ejector pins must be located in position where they will eject the article efficiently without causing distortion of the part. They are worked by a common ejector plate or a bar located under the mold, and operated by a central hydraulic ejector ram. The ejector pins are fitted either to the bottom force or to the top force depending on whether it is necessary for the molding to remain in the bottom half of the female part or on the top half of the male part of the tool. The pins are usually constructed of a hardened steel to avoid wear.
|
